About FAQ Contact Call (808) 219-0537
Frigidaire ovens

Frigidaire oven repair, from F10 to the door lock

On a Frigidaire stone-baked pizza oven, F10 can mean nothing more than a Pizza Shield on the wrong rack. Frigidaire wants the shield in position 7, then a reset and a fresh pizza preheat.

Stainless pro-style range with two oven doors and six burners on top
Air Fry ovens

Why does a Frigidaire Air Fry oven smoke or bake unevenly?

Usually something is sitting on the oven floor. Frigidaire says the convection element in its Air Fry ranges runs at more than double the power of a regular one, and that air has to move freely. So nothing goes on the bottom: no foil, no liner, no pan. A baking sheet a rack or two under the Air Fry Tray catches crumbs instead. Air Fry is a single-rack mode; convection handles several racks. If the floor is clear and the smoke or uneven heat continues, the element or fan needs a look.

Display codes

Frigidaire range codes and what to try first

These are the labels Frigidaire publishes for its electric ranges. Most call for the same owner step first: power off for up to 30 seconds.

CodeFrigidaire labelWhat it points toTry firstIf it returns
F10Thermal runawayThe oven is reading more heat than it shouldSwitch it off and let it cool; on a pizza oven, check the shield is on rack 7Sensor, control or relay check
F30, F31Open probe, shorted probeThe temperature probe circuit reads open or shortedCut power for up to 30 secondsProbe and wiring test
F90 to F94Door lock issueThe lock motor or switch did not do what the control askedPress UNLOCK and follow the on-screen code, then a power resetLock assembly check
F40, F41Cooktop lock outThe control has locked the cooktop sidePower reset at the plug or breakerControl diagnosis
F1, F3, F20, F26Shorted key pad; communication errorA stuck key, or boards not talking to each otherPower resetKeypad or board work

Frigidaire oven faults we see most

Some of these are settings or habits, and Frigidaire's own support pages say so. The rest are parts. Here is how to tell the two apart before you book.

Door stays locked

After Self Clean the door unlocks only once the oven has cooled. Still locked when cold points to the lock.

d-O on Steam Clean

The door was opened mid-cycle, so the water never got hot enough. Restart with the door shut.

Runs hot

Give it a full preheat, empty, door closed. Still hot after bakeware and rack checks means calibration or a sensor.

Cuts out, then resumes

Some Frigidaire electric ranges have a safety thermostat that kills power on overheating and restarts once things cool.

Oven light dead

The bulb sits behind a glass shield at the back and needs a heat-rated lamp. Handle it with a cloth.

Rusty drip bowls

Frigidaire itself names salt air in seaside homes as a cause of pitted bowls on coil ranges.

Frigidaire oven numbers

Rack 7
Pizza Shield position on stone-baked models
30 sec
Power off to clear most codes
20 min
Longest normal full preheat
300°C
Heat rating for the oven lamp

Sources: Frigidaire owner support (oven error codes and alarms guide; ranges error code guide; oven is too hot); Frigidaire electric range use and care guide 808575804

01

Frigidaire oven codes

The shield is probably on the wrong rack. Frigidaire puts the rack and Pizza Shield in position 7 on its stone-baked models, though some vary, so check your guide. Move it, reset the oven, and run the pizza preheat again.
No, switch the oven off and let it cool first, because F10 means it sensed more heat than normal.
Turn its breaker off for up to 30 seconds, then on again. Frigidaire points out that this also resets anything else sharing that circuit, so clocks elsewhere may need setting. A code that comes straight back after a clean reset is no longer a glitch.
The door was opened while the cycle ran. That lets the cup of water on the oven floor cool off, so it never reaches cleaning temperature. Close the door and start the cycle over. When it ends, the gasket may be damp; Frigidaire says to leave it, not rub it dry.
Frigidaire suggests three hours, or the medium soil level, for an ordinary clean. Take the racks out first.
02

Cleaning, Air Fry and care

Switch the oven off at the breaker, wait 45 seconds, switch it back on, then open the settings menu and turn demo mode off. In demo mode the display works but the oven will not heat, which looks a lot like a failed element.
Yes, hold OFF for 6 seconds and the door and controls unlock.
Some of that is normal at first. Frigidaire's Gallery induction quick guide suggests running the oven on bake at 350°F for about 30 minutes before you cook in it, and says early smoke and noise are expected. Fans may also run to cool parts after the range is off. Smoke that keeps coming after that first burn-off, or a fan that never stops, is worth a visit.
Frigidaire sends owners back to the installer when a unit went in within the past 30 days. After that window, it is a normal repair or warranty call, and our warranty repair page explains how that works.
Line a baking sheet on a lower rack with foil if you like, but never lay foil on the oven floor, where Frigidaire says it blocks air and heat.

Frigidaire oven showing a code?

Talk to a person
(808) 219-0537
Call Now →
Sun through Thu 6am-12am | Fri 6am-3:30pm
Call (808) 219-0537